Page 1 of 1
DT5120 Guard or something similar
Posted: Tue Feb 02, 2010 11:35 pm
by Steve M
Looking for a DT5120 guard or a similar down-curved guard for a single hand sword.
http://www.arts-swords.com/images/DT5120-2.jpg
Thanks
Steve
Re: DT5120 Guard or something similar
Posted: Wed Feb 03, 2010 1:50 am
by Greg
Just for the guard, or a sword with the aforementioned guard? And I'd imagine you're looking for this secondhand, rather than asking us to post places where you can buy them new, correct?
Re: DT5120 Guard or something similar
Posted: Wed Feb 03, 2010 5:11 am
by Steve M
Looking for just the guard for a project idea I had. If there's a place where I can find one new that would work too. I just figured since it's a rare design it'd be hard to find.
Re: DT5120 Guard or something similar
Posted: Wed Feb 03, 2010 5:36 am
by Greg
Posting this over at Sword Forum International would probably be your best bet. That group of people is, I think, most likely to have spare parts lying around.
Re: DT5120 Guard or something similar
Posted: Wed Feb 03, 2010 6:36 am
by Steve M
Thanks Greg, already did, as well as MyArmoury.com; just making sure all my bases are covered.
Re: DT5120 Guard or something similar
Posted: Tue Feb 09, 2010 4:37 pm
by Peter Remling
Steve: I know you're only looking for a similar guard but, the MRL Deal of the Day is the Sword of Cassel
http://www.museumreplicas.com/p-728-swo ... assel.aspx
I waited to point it out, as it was about due for a Deal of the Day
