I did a little research, and found out that this is done by quite a few leather crafters, and works quite well. It is good for snaps, rivets and grommets as well, though those aren't as useful for MERF stuff.Echadron wrote: An arbor press might work really well. They tend to be on the order of 1/2-1 ton, but the way they work you can just turn the wheel lightly to apply less than the full force.
feedback on leather stamps? (design elements of Eriador)
Re: feedback on leather stamps? (design elements of Eriador)
- Elleth
- êphal ki-*raznahê
- Posts: 2940
- Joined: Wed Nov 03, 2010 5:26 am
- Location: in the Angle; New England
Re: feedback on leather stamps? (design elements of Eriador)
regarding an embossed wheel - that's a cool idea! I've thought about it, but the shapeways process won't give me clean lines all the way around unless I do it in something cast like bronze. Might be worth a try though, at least for a smaller size design.
I use a small arbor press, and I'd imagine a sturdily built drill press could do the same job. I wonder a bit about whether all the bearings all up inside there are sturdy enough to do so repeatedly without damage though - I've no idea.
I use a small arbor press, and I'd imagine a sturdily built drill press could do the same job. I wonder a bit about whether all the bearings all up inside there are sturdy enough to do so repeatedly without damage though - I've no idea.
Persona: Aerlinneth, Dúnedain of Amon Lendel c. TA 3010.
- Elwindil
- Silent Watcher over the Peaceful Lands
- Posts: 201
- Joined: Sun Dec 01, 2013 6:34 am
- Location: Kansas
Re: feedback on leather stamps? (design elements of Eriador)
I wasn't sure if it would be doable for some of the more intricate designs that you posted or not...since it's a thing I'm not all that familiar with. I'm slowly going to be teaching myself how to do all the leatherworking I'll need by trial and error...most likely lots of error. *laughs* but that's how you learn.
- Iodo
- Thangailhir
- Posts: 2112
- Joined: Mon Sep 25, 2017 5:58 pm
- Location: North west england UK
- Contact:
Re: feedback on leather stamps? (design elements of Eriador)
I tryed it today at work and it seemed to be effective although you can't get as much force as with an arbour press. I made some simple stamps from round bar and clamped them in the chuck, which works and gives you even pressure every time, providing the leather stamp bar is bottomed out so it's solid. I got some funny look from fellow engineersHas anyone tried attaching the stamp to a drill press. I'm wondering if you'd get a clearer, cleaner stamp than by using a mallet.
They should be, all the bearings inside a decent drill press should be able to take a large amount of force.I wonder a bit about whether all the bearings all up inside there are sturdy enough to do so repeatedly without damage though - I've no idea.
Hope this information is helpfull
Gimli: It's true you don't see many Dwarf-women. And in fact, they are so alike in voice and appearance, that they are often mistaken for Dwarf-men.
Aragorn: It's the beards.
Aragorn: It's the beards.
- Peter Remling
- Athel Dunedain
- Posts: 3742
- Joined: Sat Feb 16, 2008 4:20 am
Re: feedback on leather stamps? (design elements of Eriador)
Thanks for experimenting. I'll give it a try sometime.