First bit
First bit
So I plunked down the money for my first but of hard kit... my ranger star. Looking forward to tromping through the mountains and trails as a ranger.
- Elleth
- êphal ki-*raznahê
- Posts: 2934
- Joined: Wed Nov 03, 2010 5:26 am
- Location: in the Angle; New England
Re: First bit
Ha! They just now sent me an alert!
I didn't see until now they used my photo of the silver one for the steel as well. Steel will have a somewhat coarser surface, and you may need to polish the pin and loops a bit to get the pin in. But I think it'll work just fine.
I can't wait to see how it looks on your cloak.
I didn't see until now they used my photo of the silver one for the steel as well. Steel will have a somewhat coarser surface, and you may need to polish the pin and loops a bit to get the pin in. But I think it'll work just fine.
I can't wait to see how it looks on your cloak.
Persona: Aerlinneth, Dúnedain of Amon Lendel c. TA 3010.
- Elleth
- êphal ki-*raznahê
- Posts: 2934
- Joined: Wed Nov 03, 2010 5:26 am
- Location: in the Angle; New England
Re: First bit
Gaerfast - I just got the notice Shapeways cancelled your steel order - frustrating, since they've printed a prior version of that star for me in steel already! :/
Anyhow, I'll get the version they've already done in steel up this evening for you. Alternately, I can sell you one of those I already had made in steel (the plain one on the left):
It does have a slightly bronzy tinge compared to regular stainless - I thought was a screwup, but Shapeways tells me that just sometimes happens with the steel prints. But if you want to go that way, I can have it in your hands sooner.
In the meantime, I've taken down the steel version from the shapeways page so no one else gets the runaround.
Anyhow, I'll get the version they've already done in steel up this evening for you. Alternately, I can sell you one of those I already had made in steel (the plain one on the left):
It does have a slightly bronzy tinge compared to regular stainless - I thought was a screwup, but Shapeways tells me that just sometimes happens with the steel prints. But if you want to go that way, I can have it in your hands sooner.
In the meantime, I've taken down the steel version from the shapeways page so no one else gets the runaround.
Persona: Aerlinneth, Dúnedain of Amon Lendel c. TA 3010.
Re: First bit
No worries. Whatever is easier for you.
Re: First bit
Elleth, I sent you a pm.