Page 1 of 1
A custom Strider's quiver.
Posted: Wed Feb 21, 2018 8:13 pm
by theowl
Re: A custom Strider's quiver.
Posted: Wed Feb 21, 2018 9:13 pm
by Iodo
That really looks the part, very impressive!
Re: A custom Strider's quiver.
Posted: Thu Feb 22, 2018 11:59 am
by Elleth
Oh that came out great! The little boot at the bottom (for the bow, right?) is an interesting touch. Have you had a chance to see how it works? I assume you need to take off the quiver to get at the bow, yes?
You're quite welcome on the buckles.
What did you use for a tongue? It looks made for it!
Re: A custom Strider's quiver.
Posted: Thu Feb 22, 2018 3:58 pm
by theowl
I fiddled around a bit with my short bow, and it works pretty well keeping everything in place. As for the tongue it's a piece of coat hanger that I hammered flat and rounded the tip.
Re: A custom Strider's quiver.
Posted: Thu Feb 22, 2018 10:52 pm
by Greg
Good gravy, that thing must hold two dozen!
The little boot at the bottom is, I believe, an actual feature of the original WETA quiver, yes?
Re: A custom Strider's quiver.
Posted: Sat Feb 24, 2018 2:56 am
by theowl
Greg wrote:Good gravy, that thing must hold two dozen!
more like a dozen and a half
Greg wrote:The little boot at the bottom is, I believe, an actual feature of the original WETA quiver, yes?
Correct, I couldn't get a good look at whether it's a stand for the bow to sit on, or a loop for the bow to pass through, but I made mine a loop because it made the most sense.